2.
Switch on device:
Set main switch on I (ON).
•
The digital display shows the current adjusted flash output.
•
The display lights up and shows READY when the adjusted flash output
is reached.
ADVICE: An integrated soft-start prevents the flash tube from damage.
It will take 1-2 seconds until the flash output is reached.
•
The modeling lamp lights up, if it was switched on, when the device
was switched off.
•
The signal AUDIO lights up, if the acoustic operational readiness was
switched on, when the device was switched off.
•
The function Photo Cell/SLAVE lights up, if photo cell or pre-flash
suppression were switched on, when the device was switched off.
3.
Switch off device:
Set main switch on O (OFF).
•
All signals will go out.
•
When the modeling lamp was switched on:
The modeling lamp will go out.
ADVICE: A special discharging electronics release the residual voltage
after switching off. You cannot stop this safety function.
10.
Adjustments
10.1.
Adjust flash output
You can adjust the power of the flashes according to the below mentioned
chart.
Flash output
Check value
F-stops
6,0
1 (full output)
5,0
1/2
4,0
1/4
3,0
1/8
2,0
1/16
1,0
1/32
15
16
