Issue Date: 09-25-07 Rev. Date: 04-24-08 Rev. Level: 03 ECN: n/a OIPM P/N: 3420203
Page 8 of 8
MAINTENANCE
1.
Always disconnect heater from power
supply before performing any maintenance
or service
.
2. Periodically clean the reflector with a
dampened soft cloth using mild detergent.
Rinse with water and wipe dry with a clean
soft cloth.
ELECTRICAL SHOCK
HAZARD
•
Serious injury or death
may occur.
•
Disconnect from electrical
supply before installing or
servicing this heater.
TROUBLESHOOTING
The obligation of Fostoria Industries, Inc. under the terms of this warranty, shall be to
supply a new part, repair of defective part, or a refund, at the company’s option with no
cost to owner for the new or repaired part. Such parts are to be returned to the factory, or
such other location as the company may designate. This warranty does not obligate
Fostoria Industries, Inc. to bear the cost of labor in replacing any assembly, unit or
component part thereof, nor does the company assume any liability for secondary
charges, expenses for installing or removal, or any other consequential losses. The
company’s maximum liability shall not in any case exceed the list price for the product
claimed to be defective.
The warranty shall not apply to any product or parts of products which have been repaired
or altered outside of Seller’s factory in any manner. Warranty is void on products that have
been determined to have been subjected to misuse, negligence or accident or which have
been used in a manner contrary to Seller’s instructions.
The warranty herein set forth is in lieu of all other warranties expressed or
implied.
Fostoria Industries, Inc. of Fostoria, Ohio 44830, warrants its products to the
owner against defects in material and workmanship for a twelve (12) month
period under normal use and service following date of manufacture or installation
when proof of such is provided to seller.
This Warranty requires that the owner, or his agent, install the equipment in
accordance with the National Electrical Code, any other applicable heating or
electrical codes and the manufacturer’s installation instructions. It further requires
that he perform reasonable and necessary maintenance on the unit. The
company is not liable for abuse or misuse of product as may be finally
determined by the company.
FOSTORIA INDUSTRIES, INC. – 1200 North Main Street - Fostoria, Ohio 44830 - (419) 435-9201
LIMITED WARRANTY
SYMPTOM POSSIBLE
CAUSE(S)
CORRECTIVE
ACTION
Element does not energize.
Not enough heat.
Too much heat.
Hot spot in tube.
1. Defective
element
.
2. Improper
connection.
1. Heater too small for application.
2. Heater mounted too high or too far.
1. Heater too large for application.
2. Heater mounted too low or too close.
1. Heater is not level.
2. Grease or moisture on tube.
1. Replace
element.
2. Check connection to power outlet.
1. Add additional heater(s)
2. Decrease mounting height or
distance.
1. Replace with smaller heater.
2. Increase mounting height or distance.
1. Adjust to a level mount.
2. Clean tube-replace if problem
persists.
