Fix Bracket “C” to the power unit with the
nuts and washers supplied (Items “A” on
the schematic on page 5). Please ensure
that the bracket is installed as shown to
enable full ac-cess to the square plastic
black box and the metal electrical junc-
tion box. Slide Bracket “B” over Bracket
“C” (once again ensure full access to the
plastic and electrical boxes is main-tai-
ned) and fix it in place, at the previou-
sly calculated length using the machi-
ne screws denoted by items “B” on the
schematic on page 5.
Check
that the plastic flaps at the exhaust
outlet for the fan move freely and have not
become jammed during shipping or whilst
working with the power unit. Connect an
appropriate length of ducting to the unit.
Do not
fix the ducting to the outlet with
screws - use
DUCT TAPE
.
Stand the assembled structure on a clean
soft surface. Ensure the underside of the
hood does not get scratched and slide
the chimneys of the assembled structure
from the top down as per the schematic
on page 5. Ensure that the holes for fi-
xing the decorative chimney are correct-
ly orientated with the holes at the top of
bracket A.
Attaching the Range Hood to the Ceiling.
The entire structure that has been pre-
assembled above, must now be hoisted
up to the ceiling. A few things have to
happen at once here: the slots (as di-
scussed below) need to be engaged and
the ductwork must make connection with
the length of ductwork on the structure.
7
This will require two strong people –do
not attempt this step on your own. Brac-
ket “B” has slots, position C per Diagram
“A” (refer to page 5), at the top that will
receive the spring clips located on Bracket
“A”
–THIS IS A TEMPORARY HOLD ONLY
–DO NOT RELY SOLELY ON THESE CLIPS
TO HOLD THE HOOD UP – THEY WON’T
.
Once “hooked” by the spring clips imme-
diately secure the structure with the ma-
chine screws at point “E” on the schematic
on page 5 –
this must be done imme-
diately and should not be skipped
. Rai-
se the upper chimney to the ceiling and
fix it to the bracket “A” with the screws
supplied “D”.
Ensure the entire structure is sturdy - se-
rious injury, death and MAJOR damage
could result should the unit not be well
connected to the frame structure within
the ceiling.
This is of utmost importance – do not go any
further until this has been tested and double
checked – the installer has sole responsibili-
ty for the safe installation of this product.
Attaching the Range Hood to the Ceiling.
The entire structure that has been pre-
assembled above, must now be hoisted
up to the ceiling. A few things have to
happen at once here: the slots (as discus-
sed below) need to be engaged and the
ductwork must make connection with the
length of ductwork on the structure.
