instructions for
vACUUM OIL & FLUID EXTRACTOR MANUAL 1.6LTR
model no:
Ms155
Thank you for purchasing a sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. sAFETy
9
9
9
Keep the extractor clean and maintain it in good condition (use an authorised service agent).
9
replace or repair damaged parts.
Use genuine parts only. Unauthorised parts may be dangerous and will invalidate the warranty.
9
Keep all non-essential persons away from the work area.
9
9
9
check extractor connections and fittings before use.
9
9
9
ensure that the tank capacity exceeds the amount of fluid to be collected.
9
8
9
DO NOT
use the extractor for any purpose other than that for which it is designed.
9
9
9
DO NOT
operate the extractor if any parts are damaged or missing as this may cause failure and/or personal injury.
9
9
WARNING!
Engine oil maybe hot when extracting.
▲
ImpoRtANt!
Ensure that you wear protective clothing, gloves, goggles, face mask as appropriate for the fluid being extracted.
9
9
WARNING! Do Not
allow uncontrolled discharge of fluids thus polluting the environment.
9
dispose of waste fluids in accordance with local authority regulations.
9
9
WARNING! Do Not
use with gasoline or other flammable liquids.
9
8
9
DO NOT
use the unit to extract dangerous chemicals, poisons, acids, alkalines or solvents.
9
8
9
the container is not designed for long term storage.
9
8
9
DO NOT
store the unit under extreme conditions.
9
8
9
DO NOT
turn the container upside down when it is holding fluids.
9
8
9
DO NOT
adapt the unit for any other purpose.
9
8
9
When not in use, store in a safe, dry, childproof area.
2. INTRODUCTION
1.6 lt capacity, constructed from composite materials, suitable for the extraction of engine or transmission oils from cars, motorcycles, marine
engines, stationary engines and industrial machinery. Also suitable for low viscosity fluids such as water. Supplied with two suction probes
and cover cap. use probes to remove engine oil through the dipstick tube.
3. spECIFICATIONs
Model no: ...................................................................Ms155
capacity: ........................................................................1.6ltr
suction probes: ............Ø8mm x 1300mm, Ø5mm x 1008mm
Fig.1
ms155| issue 1 22/07/15
Original Language Version
© Jack sealey limited
refer to
instruction
manual
