Foster GHOST 2451 946, Manual

Page: 12 / 24

EN
INSTALLING THE
COOKER HOOD
1.
2.
3.
4.
Fix the downdraft inside the cabinet, using the
special fixing brackets supplied with the pro-
duct (Fig. 3) .
Insert the brackets in the lower side of the
downdraft (Fig. 3) , in such a way that there
is a 2 mm distance between the lower side of
bracket and the bottom of the cabinet (Fig. 3) .
This distance will allow the traction to be po-
sitioned downwards of the product, at the mo-
ment of fixing, in order to have the stainless
steel trim perfectly adhering with the work
surface. Before inserting the screws, please
make sure that the appliance is perfectly per-
pendicular with the work surface.
Remove the two screws of the box cover to
connect the power supply.
5.
6.
Before carrying out the appliance installation,
please check that all components are not da-
maged, in such a case contact your retailer and
do not carry out any installation operation.
Before the installation of the Downdraft, plea-
se remove the safety piece you can see in the
picture (Fig. 1) . Furthermore, please read care-
fully all of the following installation instructions.
● Use an air exhausting pipe whose maximum
length does not exceed 5 meters.
● Limit the number of elbows in the piping,
since each elbow reduces the air capacity of
1 linear meter. (Ex.: if you use no. 2 x 90° el-
bows, the length of piping should not exceed
3 meters).
● Avoid abrupt direction changes.
● Use a 150 mm. constant diameter pipe for
the whole length.
● Use piping approved by standards in force.
The manufacturer shall not be deemed re-
sponsible for air capacity or noise problems
caused by failure to comply with the above
instructions and no warranty on the product
shall be provided.
Before making the hole, check that there are
no structural or other parts inside the cabinet,
where the appliance is to be placed, which
could hinder a proper installation.
Check that the dimensions of the Downdraft
and the ones of the cook top are compatible
with the cabinet so that the installation can be
carried out properly.
Make a rectangular opening, 842 x 100 mm in
size, in the back of the cook top for the 90 cm
model and 542 x 100 mm for the 60 cm model
and 1142 x100 mm for the 120 cm model. In
the version with the motor already installed,
remove the screws and the suctioning unit
in order to insert the down-draft in the hole
made.
Put the Downdraft in the opening, inserting it
from above as shown in (Fig. 2) .
Remove the “m3” screw that secures the con-
nector inside the box.
12 SU-DD2