Forza FDC-003K, User Manual

Page: 6 / 18

USB port
Network/Fax/Phone port
RS-232 port Intelligent slot
Step 3: Communication connection
Communication port:
Step 4: Connect the network surge protection
The UPS has two network cable jacks for network lines
Step 5: Disabling and enabling the EPO function
Keep pins 1 and 2 closed for UPS normal operation. To activate EPO feature, remove the wire between pin 1 and 2.
Step 6: Turning on the UPS
Press the
ON/Mute
button on the front panel for two seconds to power on the UPS.
Note: The battery charges fully during the first five hours of normal operation. Do not expect full battery run capability during
this initial charge period.
2-4. ForzaTracker monitoring software
ForzaTracker
is a new generation of UPS monitoring software, which provides user-friendly interface to monitor and control
your UPS system. This unique software provides safe auto-shutdown for multi-computer systems during power failures. With
this software, users can monitor and control any UPS on the same LAN no matter how far they might be from the UPS.
To allow for unattended UPS shutdown/start-up and status monitoring, connect one end of the communication cable to
the USB/RS-232 port, and the other end to the communication port of your PC. With the monitoring software installed, you
can schedule UPS shutdown/start-up and monitor UPS status through PC.
The UPS is equipped with intelligent slot perfect for either SNMP or AS400 card. When installing either SNMP or AS400
card in the UPS, it will provide advanced communication and monitoring options.
Note : The USB port and RS-232 port cannot be used at the same time.
Entrada Salida
•
• Connect a single line modem/phone/fax cable into the network surge-protection “IN” jack on the rear panel of the UPS.
Connect a network cable from the OUT jack on the rear of the UPS to a port on a PC or network device such as a route.
Closed for UPS normal
operation.