Forza FDC-003K, User Manual

Page: 3 / 18

1. Introduction
Thank you for purchasing the Forza Atlas 3000 Online UPS. To enjoy all the features and benefits of this unit, please read
and follow all installation and operation instructions thoroughly before unpacking, installing or operating this device. After
you have read this manual, keep it in a safe place for future reference.
The information contained in this manual covers the 3000 VA uninterruptible power system, its basic functions, operating
procedures, options available and troubleshooting guide. It also includes information on how to ship, store, handle, and
install the equipment.
1-1. Transportation
Make sure to transport the UPS system only in the original package to protect it against shock and impact.
1-2. Preliminary steps
Water condensation may occur if the UPS is unpacked in a very cold environment and then moved to a warmer location.
The UPS must be thoroughly dry before being installed. Failure to do so may increase the risk of electric shock.
Do not install the UPS system near water or in moist environments.
Do not install the UPS system where it would be exposed to direct sunlight or near a heater or heating vent.
Do not block ventilation holes in the UPS housing.
1-3. Initial setup
1-4. Important safety instructions
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Do not connect appliances or equipment that may overload the UPS system (such as a laser printer) to the output
sockets.
Place cables in such a way that no one can step on or trip over them.
Do not connect domestic appliances, such as hair dryers, to the UPS output sockets.
Connect the UPS system only to an earthed shockproof outlet which must be easily accessible and close to the UPS
system.
Use CE-marked cables for connections between mains, the UPS and equipment (shockproof outlet).
Use CE-marked power cables to connect the loads to the UPS system.
During the installation of this equipment, make sure that the sum of the leakage currents of the UPS and the connected
loads shall not exceed 3.5 mA.
Do not disconnect the mains cable on the UPS system or the building wiring outlet (shockproof socket outlet) at any time,
since this would cancel the protective earth of the UPS system and of all connected loads.
Connect the UPS only to a grounded socket that meets electrical safety guidelines.
Locate the UPS near a wall socket. Do not use an extension cord between the UPS and the socket.
In the event of an emergency, press the OFF/Enter button and disconnect the power cord from the AC mains to properly
disable the UPS. Do not allow any kind of liquid or foreign object to enter this UPS unit.
Do not place beverages or any other containers with liquid on or nearby the unit.
The UPS can be operated by any individuals with no previous experience.