FENCING INSTALLATION: VERSAI
3
INTRODUCTION
READ INSTRUCTIONS COMPLETELY BEFORE
STARTING INSTALLATION
It is the responsibility of the installer to meet all code and
safety requirements, and to obtain all required building
permits. The fencing installer should determine and
implement appropriate installation techniques for
each installation situation. Fortress Building Products and
its distributors shall not be held liable for improper or
unsafe installations.
Before You Begin
Contact your local Building Code Department for required
permits and laws regarding your fence project.
If applicable, also contact your Home Owners Association
for rules and regulations regarding fence installations in
your neighborhood.
Call 811 before you dig post holes to locate and identify
any buried utilities.
Note
•
When cutting Fortress Fencing, it is very important to
complete the following at cut points:
• Remove all metal shavings from the cut area.
• File any sharp edges left by cutting. Thoroughly wipe and
remove any filings, grime, or dirt.
• Apply two coats of Fortress zinc based touch-up paint to
the cut area. If touch up is at rail ends, allow paint to dry
before connecting bracket to post.
• Be sure to remove any metal shavings from the surface of
Fence.
Torx Safety Tips
• Always use the lowest speed setting on drill.
• To reduce chance of bit breakage, start tightening with drill
on low torque setting and work up until screw is secured.
Tip: Pre-drill holes with 5/32” [4mm] drill bit.
