FENCING INSTALLATION: VERSAI
17
Do not
measure from
post
Measure
from back
of bracket
Fig. 1
Fig. 2
Measure the panel opening
Step 2:
Mark Panel with Cut Points
1. Use panel opening length found in step 1 above as cut
length.
2.
Use a tape measure to measure from center of panel and
mark cut point of first end of panel. As shown in Fig. 1.
3. Use Speed Square to add mark cut points.
4. Repeat for second end of panel.
Note:
• When cutting a panel to length, it is recommended that
an equal amount be cut from each end of panel. By doing
so, this will alter the picket spacing which can affect
meeting the national pool code.
Tip:
• Measure from the back wall of the bracket to the back wall
of the bracket on other post. As shown in Fig. 2.
•
Confirm that the length between each top, middle &
bottom brackets are equal.
•
Always design your layout to minimize the number of
panels that need to be cut.
Fig. 1
Panel Cut 1
Center of Panel
Panel Cut 2
