12
FENCING INSTALLATION: VERSAI
When installing this bracket,the brackets must be slid
over the top of the post prior to installing any panels, in
the direction they will be installed. This is a bracket that
has a fixed position on the post and change of direction is
not possible once panel installation begins. For installation
of this bracket, the set up laid out for the EXW-204 Bracket
can be utilized in the same manner by attached the panel
to the bracket initially, then installing the Self-Tapping
Screw at the end of the process. When positioning the
brackets on the post, the bottom bracket (of each panel
connection) should be installed upside down. This ensures
that the rails line up for the direction change.
Step 1:
Mark Bracket Hole Locations For EX-104 & EXS-104
1. Mark the centerline of each post with a pencil.
2. Take measurements used in Fig. 1 - 9
to mark top,
middle & bottom bracket hole locations onto posts.
Tip:
• Remove all metal shavings from posts before brackets are
installed to post to prevent rust stains & prevent corrosion.
Note:
• All panels should be installed with the bottom face of the
bottom rail a minimum of 2” [50mm] above ground
surface.
Fig. 1
Fig. 2
A
3 Rail Panel
2 Rail Panel
B
A
