20
FENCING INSTALLATION: VERSAI
Fig. 1
POST CUTTING & PRESSED DOME CAP INSTALLATION
Install Panel Into higher Post First
Rake Panel Down
Slope
Step 1:
Trim Excess Post Material
1. Determine required post height. Post should extend 2”
[50mm] above highest picket or rail. As shown in Fig. 1.
2. Make cut marks on posts.
3. Use the Reciprocating Saw or Portable Bandsaw to trim the
top of the post to required height. As shown in Fig. 2.
4. Use file to clean cuts.
5. Remove any metal shavings and dust with a brush or rag.
6. Apply spray paint to cut areas.
Reference
step 4 of
panel
painting on page 19.
Fig. 1
Fig. 2
2”
[50mm]
Tip:
• Have a second person supporting opposite end of panel.
•
DO NOT over tighten the nut when attaching the panel to
the bracket. Over tightening can result in damage
to the rail.
