INSTALLATION GUIDE
STRATCO EZI-SLAT FENCING
INSTALLATION GUIDE
BEFORE YOU START
Carefully read these instructions and refer to them constantly during each stage of construction. If you do not have all the necessary
tools or information contact Stratco for advice. Before starting, lay out all components and check them against the delivery docket.
The component description identifies each key part and the component layout diagram indicates their fastening position.
Double check all dimensions, levels and fixing locations before cutting or fastening componentry. It is recommended that the
installers erecting the structure have had some previous building experience.
IMPORTANT NOTE:
There are two Stratco Ezi-Slat Fencing options available.
Engineered Fence Solution:
Design fence loading determined in accordance with ASCE/SEI 7-10: Minimum Design Loads for Buildings and other structures.
Non-Engineered Panels:
Suitability of the slat supporting structure has not been considered and the installer is responsible for ensuring the supporting
structure is capable of sustaining imposed loading. If in doubt, seek professional engineering advice.
Note:
Ezi-Slat horizontal panels are not designed as a balustrade or railing system.
TOOLS REQUIRED
•
Drill
• 1/8” (3mm) and 1/4” (6mm) drill bits
• 25/64” (10mm) masonry drill bit
• Phillips head driver
• Hex head driver
• Rubber mallet
• Tape Measure
• String line
• Spirit Level
• Saw (either a drop saw with a fine-tooth blade or hacksaw)
• Manual or mechanical auger
ADDITIONAL ITEMS
The components supplied do not include fixings to attach
the unit to an existing structure or concrete/masonry
anchors for the column installation. If required they must be
purchased as additional items.
