Fortress Technologies S1, Manual

Page: 37 / 63

32
Remote Key Fobs
The Remote Key Fobs can be used
to control the system from up to 150
feet away from the main panel. You
can arm the system from outside the
house as you leave in the morning,
and disarm the system before open-
ing the door when you come home.
The remote’s four buttons allow you to arm the system (in
either mode), disarm the system, or trigger the alarm im-
mediately.
Programming a Remote Key Fob
1. Press and hold the Set button until the panel says,
“Please trigger remote control,” and the light begins
to flash red. At this point, release the Set button.
2. Press any button on the Remote Key Fob. The panel
will say, “Remote control added successfully.”
3. Press and release the Power button once to exit listen-
ing mode.
To program an accessory to the main panel, set the panel
into a listening mode, and then trigger the accessory so that
it will send a signal to the main panel to be saved in mem-
ory.
Note: Whenever programming an accessory, you should
make sure that other accessories do not accidentally trigger.
For example, while programming a new door sensor, you
may first want to turn off any motion detectors that would
pick up your motion.
Programming Accessories using the Main Panel