Hardware installation
Resetting a FortiController-5913C board
FortiController-5913C Session-Aware Load Balancing Cluster (SLBC) System Guide
10-500-259409-20160210
19
9
Turn both handles to their fully-closed positions.
When the handles are fully-closed they lock into place.
10
Carefully slide the board completely out of the slot.
11
Re-attach the protective metal frame if you are going ship the FortiController-5913C
board or store it outside of a chassis.
Resetting a FortiController-5913C board
You can use the following procedure to reset a FortiController-5913C board without
removing it from the chassis.
To reset a FortiController-5913C without removing the board from the chassis
You do not have to loosen the retention screws or adjust the position of the
FortiController-5913C board to use this procedure.
To complete this procedure, you need:
•
An ATCA chassis with a FortiController-5913C board installed
•
An electrostatic discharge (ESD) preventive wrist strap with connection cord
1
Attach the ESD wrist strap to your wrist and to an ESD socket or to a bare metal
surface on the chassis or frame.
2
Unlock the right handle by squeezing the handle lock.
3
Pivot the right handle open.
The handle can only pivot a short distance. Pivoting the right handle turns off the
microswitch which powers down the board, turning off all LEDs except the IPM LED
which turns on.
Fully Clo
s
ed
and Locked
Alignment Pin
Handle
Clo
s
e
Alignment Pin
Handle
FortiController-5913C boards must be protected from static discharge and physical
shock. Only handle or work with FortiController-5913C boards at a static-free
workstation. Always wear a grounded electrostatic discharge (ESD) preventive wrist
strap when handling FortiController-5913C boards.
Unlock
Handle
