Fortinet FortiController-5913C, System Manual

Page: 7 / 30

FortiController-5913C system Front panel LEDs and connectors
FortiController-5913C Session-Aware Load Balancing Cluster (SLBC) System Guide
10-500-259409-20160210
7
http://docs.fortinet.com/
LEDs
Table 1: FortiController-5913C LEDs
LED State Description
OOS
(Out of Service)
Off Normal operation.
Amber A fault condition exists and the FortiController-5913C
blade is out of service (OOS). This LED may also flash
very briefly during normal startup.
PWR (Power) Green The FortiController-5913C is powered on.
STA (Status)
Off The FortiController-5913C is powered on.
Flashing
Green The FortiController-5913C is starting up. If this LED is
flashing at any time other than system startup, a fault
condition may exist.
F1 and F2
Amber The correct cable is connected to the interface and the
connected equipment has power.
Flashing
Amber Network activity.
Off No link is established.
B1 and B2
Green The correct cable is connected to the interface and the
connected equipment has power.
Flashing
Green Network activity at the interface.
Off No link is established.
MGMT
Link/Act
(Left
LED) Solid
Green Indicates this interface is connected with the correct
cable and the attached network device has power.
Blinking
Green Indicates network traffic on this interface.
Off No Link
Speed
(Right
LED) Green Connection at 1 Gbps.
Amber Connection at 100 Mbps.
Off Connection at 10 Mbps.
IPM
Blue The FortiController-5913C is ready to be hot-swapped
(removed from the chassis). If the IPM light is blue and no
other LEDs are lit the FortiController-5913C has lost
power
Flashing
Blue The FortiController-5913C is changing from hot swap to
running mode or from running mode to hot swap. This
happens when the FortiController-5913C is starting up or
shutting down.
Off Normal operation. The FortiController-5913C is in contact
with the chassis backplane.