INSTRUCTIONS
8
Placing the Splitter Screen
1.
Step 4 - Installing the Splitter Screen Sub-Assembly
Remove the Temporary Braces on the Splitter
Screen
If there are any temporary braces on the splitter screen, remove
them at this time.
Locate the Splitter Screen Sub-Assembly and place it in front of
the Inflow pipe right on the center between both Cages. Push the
Splitter Screen against the front Baffle wall and make sure the top
side mounting plates are placed in the interior of the cages.
2.
Attach the Bottom Anchor Bolts
There are two mounting plates located on the bottom of the cage.
Mark the hole locations on the slots located on the mounts and
using a Rotary Hammer Drill with a 3/8” Drill Bit drill the anchor bolt
holes. Next, Insert the 3/8” Wedge anchor bolts and fully tighten
the anchor bolts using a Power Drill with a 9/16” Socket.
4.
Installing the Right Cage Sub-Assembly
Finally, place the Right Cage Assembly on the opposite side. Make
sure the Louver material is facing back towards the outflow pipe.
Next, repeat the previous steps pre drill the holes located on the
mounting plates and secure the cage using the provided 3/8” wedge
anchor bolts. After both cages are secured, step 3 is now complete.
5.
