Fortec Star CM1-BT1, Manual

Page: 50 / 90

Using the Module 41
CMx-BTx
Exception Blink Codes
In the case of an error, the BMC shows a blink code on the STATUS-LED. This error code is also
reported by the BMC Flags register. The Exception Code is not stored in the Flash storage and
is cleared when the power is removed. Therefore, the “Clear Exception Code” command is not
supported.
Table 4-2: BMC Exception Blink Codes
BMC Flags
The BMC Flags Register returns the last detected exception code since power up.
4.2 Watchdog Timer
The BMC Watchdog activation is caused by under voltage protection. The Watchdog LED gets
flashed after restart but only if the power supply reaches 4.2V.
Blink Code Error Message
0
NOERROR
2
NO_SUSCLK
3
NO_RSMRST
4
NO_SLP_S4
5
NO_SLP_S3
6
BIOS_FAIL
7
RESET_FAIL
8
RESETIN_FAIL
9
NO_ATX_PWRGD
10
+VCC_S (No core voltage)
11
+VNN_S (No GFX voltage)
12
+VDDQ (No memory voltage)
13
+V1P0A (No +V1P0A voltage)
14
+V1P5S (No +V1P5S voltage)
15
+V3P3A (No +V3P3A voltage)
16
+5V_SBY (No stand-by voltage)
17
+5V_ATX (No 5V main [AT/ATX] voltage)
18
+V3P3_ATX (No 3.3V main [ATX] voltage)
19
+V3P3_PCI (No +V3P3_PCI voltage)
20
NO SYSTEM_S_PG (One or more S-voltages missing)
21
NO_CORE_PWROK
22
NO_PMIC_DRAM_PWROK
23
CRITICAL_TEMP