Options
3
Production
Feeder
The
production f
eeder is a feeder that can be loaded with a high number of documents. This
feeder is intended to be used for Business Reply Envelopes (BRE), but also 'standard'
documents up to 356 mm (14") length can be processed with it.
Installing the
Production
Feeder
The
production f
eeder should be installed at the position of feeder no. 1 and/or 4. If you
install
it
on position 4, you cannot use position 2 and 3 for document feeders.
To install the
production f
eeder as follows:
1.
Lift the paper feed rollers with the front edge of the
production feeder
.
2.
Move the
production feeder
forward until it hooks behind the frame axle.
3.
Connect the connector A to the socket B.
The
production
is auto-detected by the system when the system is switched on.This
makes it easy to switch over from the standard document feeder tray to the
production
feeder
and vice versa.
To make use of a
production feeder
it is not necessary to (re-)program the jobs.
To allow easier hooking on of the
production feeder
it is advised
to put
the feeding plate in the rear position.
21
| Page 21 | jan-06-2012 13:58 |
3
