Ford FOCUS LV, Manual

Page: 25 / 154

-25-
Keys and remote controls
To programme new remote controls •
turn the ignition key to position II four
times within six seconds.
Turn the ignition to position • 0 . A
tone sounds to indicate that it is now
possible to programme the remote
controls for ten seconds.
Press any button on a new remote •
control. A tone will sound as
confirmation. Repeat this last step
for all your remote controls, including
your original. Do not remove the key
from the ignition when pressing the
button on this remote control.
Switch the ignition back on (position •
II
) or wait for ten seconds without
programming another remote
control to end the key programming.
Only the remote controls which you
have just programmed are now able
to lock and unlock the vehicle.
Reprogramming the unlocking
function
Note:
When you press the
unlock
button either all the doors are unlocked
or only the driver’s door and the luggage
compartment lid are unlocked. Pressing
the
unlock button again unlocks all the
doors.
GENERAL INFORMATION
ON RADIO FREQUENCIES
WARNING
The radio frequency used by
your remote control can be used
by other short distance radio
transmissions (e.g. amateur radios,
medical equipment, wireless
headphones, remote controls and alarm
systems). If the frequencies are jammed,
you will not be able to use your remote
control. You can lock and unlock the
doors with the key.
Note: You could unlock the doors if you
press the buttons on the remote control
unintentionally.
The operating range between your
remote control and your vehicle varies
depending on the environment.
PROGRAMMING THE
REMOTE CONTROL
You can programme a maximum of eight
remote controls to use with your vehicle
(including any supplied with your vehicle).
The remote controls must remain inside
the vehicle during the programming
procedure. Fasten the front seat belts
and close all doors to ensure that
conflicting chimes do not sound during
programming.
E78253
E78254