Ford EVEREST 2015, Owner'S Manual

Page: 241 / 437

1. Make sure the headlamp control is in
OFF position and open the liftgate.
2. Remove the tail lamp cover starting
from the outboard edge using a flat tip
screw driver.
3. Remove the two bolts from the lamp
assembly.
4. Disconnect the electrical connector
and gently pull out the lamp assembly.
B
C
A
E206199
Rear direction indicator. A
Stop/Rear Position Lamp. B
Rear Position lamp. C
1. Remove the bulb socket from the lamp
assembly by turning it
counterclockwise.
2. Remove the bulb by;
• Rear direction indicator- Gently
pushing it into the socket and
turning it counterclockwise.
• Stop/Rear Position Lamp- Gently
pushing it into the socket and
turning it counterclockwise.
• Rear position lamp- Gently pulling
the bulb from the socket.
Install the new bulbs in reverse order from
the steps above.
Note: If your vehicle is fitted with LED
Stop/Rear Position Lamps these are
designed to last the life of the vehicle and
only the Rear Direction Indicator bulb is
replaceable.
Type 2
Tail, Brake, Reversing Lamp and
Direction Indicator
C
B
A
1
E133685
Direction indicator A
Tail and brake lamp B
Reversing lamp C
1. Remove the screws.
2. Remove the lamp lens.
3. Remove the bulb.
Replacing a Reverse Lamp Bulb
1. Open the liftgate.
2. Remove lift gate inner grab handle
cover using a standard flat tip screw
driver.
3. Rremove the handle by unsrewing the
two screws using a standard cross tip
screw driver.
4. Remove the lift gate inner trim panel
to access the reverse lamp
5. Remove the bulb socket from the lamp
assembly by turning it
counterclockwise.
239
Everest (TEC), EB3B-19G219-YAA enAUS
Maintenance