Ford EVEREST 2015, Owner'S Manual, Page: 236 / 437

A
E208053
Front of Vehicle A
For item location: See Under Hood
Overview (page 230).
1. Switch the ignition off.
2. Connect and secure a suitable hose on
the filter drain plug.
3. Route the other end of the hose to a
suitable container.
4. Loosen the drain plug by approximately
1.5 turns.
5. Switch the ignition on to activate the
in-tank pump.
6. Allow the water to drain.
7.
Switch the ignition off.
8. Tighten the drain plug and remove the
hose.
9. Start the engine and check for leaks.
Note: The water-in-fuel indicator lamp will
go out after approximately 2 seconds, with
the engine running.
CHANGING THE 12V BATTERY
WARNING
For vehicles with start-stop the
battery requirement is different. You
must replace the battery with one of
exactly the same specification.
Note: Where applicable you must
reprogram the audio system using the
keycode.
The battery is located in the engine
compartment. See
Maintenance (page
228).
CHECKING THE WIPER
BLADES
E142463
Run the tip of your fingers over the edge of
the blade to check for roughness.
Clean the wiper blades with washer fluid
or water applied with a soft sponge or
cloth.
CHANGING THE WIPER
BLADES
Changing the Windshield Wiper
Blades
Note: The windshield wiper blades are
different in length. If you install wiper blades
of the wrong length, the wiper blades can
clash damaging the wiper system.
234
Everest (TEC), EB3B-19G219-YAA enAUS
Maintenance