The remote entry system allows you
to lock or unlock all vehicle doors
and liftgate, open the liftgate
window without a key and activate
the panic alarm.
The remote entry lock/unlock
feature operates in any ignition
position. The liftgate glass feature
operates as long as the vehicle’s
speed is less than 3 mph (5 km/h).
The panic feature operates with the
key in the off position.
If there is any potential remote keyless entry problem with your vehicle,
ensure
ALL
remote entry transmitters are brought to the authorized
dealer to aid in troubleshooting.
Two-step door unlocking
1. Press
and release to unlock the driver’s door.
Note:
The interior
lamps will illuminate (refer to the
Illuminated entry
feature later in this
section) if the control on the overhead lamp is
not
set to the
off
position and the perimeter alarm system (if equipped) will deactivate.
2. Press
and release again within three seconds to unlock the
passenger doors, the liftgate and liftgate window.
The battery saver feature will turn off the interior lamps 30 minutes after
the ignition is turned to the off position.
One-step door unlocking
If the one-step door unlocking feature is activated, press
and release
once to unlock all of the doors, the liftgate and liftgate window.
Note:
The interior lamps will illuminate (refer to the
Illuminated entry
feature
later in this section). If the control on the overhead lamp is in the door
position, the perimeter alarm system (if equipped) will deactivate.
Switching from two-step to one-step door unlocking
Your vehicle comes with two-step unlocking enabled. Unlocking can be
switched between two-step and one-step door unlocking by pressing and
holding both the
and
buttons simultaneously on the remote entry
transmitter for approximately four seconds. The parklamps will flash
twice to indicate that the vehicle has switched to one-step unlocking.
Repeat the procedure to switch back to two-step unlocking.
Locks and Security
156
2010 Explorer
(exp)
Owners Guide, 2nd Printing
USA
(fus)
