Deactivating/activating the Belt-Minder
姞
feature (if equipped)
Read Steps 1 - 4 thoroughly before proceeding with the
deactivation/activation programming procedure.
The driver Belt-Minder
威
feature can be deactivated/activated by
performing the following procedure:
Before following the procedure, make sure that:
•
The parking brake is set
•
The gearshift is in P (Park)
•
The ignition switch is in the off position
•
The driver and passenger safety belts are unbuckled
WARNING:
While the design allows you to deactivate your
Belt-Minder
威
, this system is designed to improve your chances of
being safely belted and surviving an accident. We recommend you
leave the Belt-Minder
威
system activated for yourself and others who
may use the vehicle. To reduce the risk of injury, do not
deactivate/activate the Belt-Minder
威
feature while driving the vehicle.
1. Turn the ignition switch to the on position. DO NOT START THE
ENGINE.
2. Wait until the safety belt warning light turns off (Approximately one
minute).
•
Step 3 must be completed within 50 seconds after the safety belt
warning light turns off.
3. At a moderate speed, buckle then unbuckle the safety belt nine times,
ending in the unbuckled state. Step 3 must be completed within
50 seconds after the safety belt warning light turns off.
•
After Step 3, the safety belt warning light will be turned on for three
seconds.
4. Within approximately seven seconds of the light turning off, buckle
then unbuckle the safety belt.
•
This will disable the Belt-Minder
威
feature for that seating position if it
is currently enabled. As confirmation, the safety belt warning light will
flash four times per second for three seconds.
•
This will enable the Belt-Minder
威
feature for that seating position if it
is currently disabled. As confirmation, the safety belt warning light will
flash four times per second for three seconds, followed by three
2009 Expedition
(exd)
Owners Guide, 2nd Printing
USA
(fus)
Seating and Safety Restraints
216
