FORCE1 RC
14
FIGURE 14
FIGURE 15
FUNCTIONS
LANDING METHODS
ALTITUDE HOLD MODE
HIGH/LOW SPEED MODE
360° FLIP
1.
Method 1 (Landing):
When flying, pull the left stick all the way down to the lowest position and
hold it until the motors stop and the drone will slowly land.
2.
Method 2 (1-Key Landing):
When flying, press the Lift/Land/Emergency Shutdown button and the
drone will land on the ground automatically (Fig. 13).
3.
Emergency Stop:
When you need to land the drone immediately, make the two rockers “toe-in”
(Fig. 12). The propellers will stop and the drone will drop down to the ground.
Altitude hold mode allows the drone to maintain a consistent altitude while still allowing the operator to
use normal flying functions. This function makes flying the drone much easier for beginners and allows for
better aerial photography.
To activate Altitude Hold, push the left stick up or down to reach a preferred altitude, then release the
stick. The drone will continue to fly at the current altitude. Repeat the steps below if you want to change
the drone altitude.
By default, the drone is in Low Speed Mode. Press the
High / Low Speed Mode button and the transmitter will
beep and enter High Speed Mode (Fig. 14).
MODE 1: Low Speed Mode is suitable for beginners.
MODE 2: High Speed Mode is suitable for experts.
To do flips, first press the Flip Mode button (Fig. 15). You’ll hear a constant beep indicating the drone is
ready to flip. Push the right stick to the utmost direction of your choice and the drone will flip accordingly.
Your drone will automatically exit Flip Mode after one flip.
NOTE:
The flip function is unavailable when the drone battery is low, and also during Headless Mode.
Only perform flips when flying in a spacious area.
