U45W Blue Jay
User Manual
11
PARTS INSTALLATION
PROPELLER INSTALLATION
CAMERA INSTALLATION
PROPELLER GUARD INSTALLATION
LANDING GEAR INSTALLATION
1. Remove the old propeller by removing the screw
using a counterclockwise rotation (Fig 18).
2. Attach the new propeller with the screw and
tighten using a clockwise rotation.
1. To install the camera, match the upper flat portion
of the camera with the notches on the bottom of the
drone and gently clip into place by applying moder-
ate pressure (Fig. 20)
2. To remove the camera, securely hold the camera and
gently slide out from the drone body while applying
moderate pressure.
1. Remove the old propeller guard by removing the
screw using a counterclockwise rotation (Fig 19).
2. Attach the new propeller guard with the screw and
tighten using a clockwise rotation.
1. Insert landing gear pillars into the drone body holes
as shown in Figure 21.
2. Tighten screws using a clockwise rotation.
3. Remove landing gear by removing the screws using a
counterclockwise rotation.
NOTE:
Flying the drone without the propeller guard can
improve power and flight time.
NOTE:
Always place your drone on level ground.
FIGURE 18
FIGURE 19
FIGURE 20
FIGURE 21
