FORCE1 RC
12
SET ORIENTATION & START MOTOR
1. Keep drone front (camera) pointed away from you.
2. Power on the drone and check propeller rotation. The left front and right rear props (A) should
rotate clockwise, while the right front and left rear props (B) rotate counterclockwise.
3. Move the left and right stick down and in (Fig. 8) to start the motor and then release.
4. Push the left stick up to take off, then release.
5. Push the left stick all the way down to land.
6. Practice this several times, and adjust the trim and rudder if you the drone tilts during takeoff/
landing.
PREFLIGHT OPERATIONS
FREQUENCY PAIRING
1. Turn on the transmitter switch
(Fig. 5)
and the power indicator light flashes rapidly. Push the left
stick all the way down to the lowest position and then release. It will return to the middle position
automatically
(Fig. 6 / 7).
The power indicator light flashes slowly, which indicates the transmitter
is ready for frequency pairing.
2. Install the battery and power on the drone.
3. Place the drone on a flat surface. Lights should go from flashing to solid, which indicates successful
frequency pairing.
IMPORTANT NOTICE: PLEASE MAKE SURE THE DRONE IS PLACED ON THE HORIZONTAL
POSITION AFTER POWERING ON THE DRONE, SO THAT THE DRONE CAN WORK WELL.
FIGURE 5
FIGURE 6
FIGURE 8
FIGURE 7
