Installing the S4810 System
31
Replace an AC power supply
To replace a power supply, follow the steps below:
4
Attach power cables.
5
The system powers up as soon as the cables are connected between the power supply and the
power source.
Note:
If a power supply fails, it must be completely replaced. There are no field servicable components in
the module itself. Refer to
to request a hardware replacement.
Note:
If using a single PSU, you must install a blank plate in the other PSU slot. Force10 recommends
using PSU0, if installing only one power supply.
Step
Task
1
Disconnect the power cable from the power supply.
2
Use the grab handle to slide the unit out of the power supply bay.
3
Using the grab handle on the replacement unit, slide it into the power supply bay.
4
Tighten the securing screws on the module with a screwdriver. Ensure that the module is secure.
5
Attach power cord to the new module.
6
The system powers up as soon as the cables are connected between the power supply and the
power source.
Step
Task