58
9. Troubleshooting
If any of the following problems occur while operating the IVS-200, before assuming a unit
malfunction has occurred, follow the troubleshooting procedures below to see if the problem can be
corrected.
IMPORTANT
If the problem cannot be corrected by performing the procedures below, turn the unit
off and then on again. If this still does not correct the problem, contact your dealer.
Problem
Check
Remedy
The STABILIZE OPERATE /
BY-PASS setting cannot be
changed by the front panel
toggle switch.
Is REMOTE CONTROL set
to REMOTE, WEB or
SERIAL?
Set REMOTE CONTROL to
FRONT.
Video input signals are not
bypassed when the unit
power is turned off.
Which VIDEO OUT
connector on the rear panel
is being used to output
video signals?
The bypass function is provided
only on VIDEO OUT 1. To
bypass through video signals,
connect a monitor to the VIDEO
OUT 1 connector.
How can I reset to factory
default?
Turn the power of the IVS-200
on while holding down the menu
control knob on the front panel.
All backed up data will be
initialized.
