FoodSaver VS1190X, Reference Manual

Page: 6 / 104

www.foodsavereurope.com 6
Parts
See FIG. 1
A
Vacuum Button
H
Lower Foam Gasket
B
Seal Button
I
Extra Wide Sealing Strip
C
Open
J
Vacuum Channel
D
Operate
K
Removable Drip Tray
E
Lock Latch
L
Vacuum Indicator Light
F
Accessory Port
M
Seal Indicator Light
G
Upper Foam Gasket
N
Handheld Sealer
Make a Bag from a FoodSaver
®
Roll
Referring to FIG. 2:
1. Using scissors, cut enough bag material from roll to hold item, plus
75mm. Be sure to cut straight.
2. Slide Lock Latch
E
to the OPEN position
C
. Open appliance lid.
Insert one end of bag material across Sealing Strip
I
.
3. Both indicator lights will turn on once the latch has been pushed all
the way down.
4. Press Seal button
B
.
5. When Seal Indicator Light
M
stops flashing and becomes
constant, sealing is complete. Slide latch
E
to OPEN position
C
,
lift lid and remove bag.
Now you are ready to vacuum seal with your new bag.
This appliance is compatible with 20cm wide rol
l
s FSR2002 and
20.7cm wide (950ml) bags FSB4802.
Vacuum Seal with FoodSaver
®
Bags
Referring to FIG. 3:
1. Place item(s) in bag, allowing at least 75mm of space between bag
contents and top of bag.
2. Open appliance lid and place open end of bag into Vacuum
Channel
J
.
3. Close lid and slide lock Latch
E
to OPERATE position
D
. Both
indicator lights will turn on once the latch has been pushed all the
way down. Push firmly, appliance will not break.
4. Press Vacuum button
A
to begin vacuum and sealing process.
Motor will continue to run until bag is fully vacuumed, then will
automatically seal.
5. When Seal Indicator Light
M
stops flashing and becomes
constant, slide Latch
E
to OPEN position
C
, lift lid and remove
bag.
Note: Let appliance cool down for 20 seconds after each use.
Using FoodSaver
®
accessories
To vacuum seal a Fresh Zipper Bag or Fresh Container:
1. Insert the connector end of the handheld sealer into the accessory
port on the FoodSaver
®
appliance.
2. Fit the end of the handheld sealer over the valve on the accessory
and make sure that it is connected firmly. Follow any specific
instructions that come with the FoodSaver
®
accessory.
Note: To vacuum seal a FoodSaver
®
Canister, remove the reservoir
(clear bottom section) of the sealer by pulling it down and off the
top section. Insert the tip of the sealer into the port on the canister.
3. Press the Vacuum and Seal button.
4. When the progress lights have stopped and the sealing progress
light has gone out, the process is complete.
Use Handheld Sealer with Vacuum
Zipper Bags
Handheld sealer can be used with Vacuum Zipper Bags.
1. Fill zipper bag, lay flat with grey circle facing upwards. Squeeze air
out, zip 3/4 of the way closed and squeeze any remaining air out
before zipping completely.
2. Press Handheld Sealer
N
over grey circle on bag and press
Vacuum button
A
.
Important Tips:
To minimize bag waste, do not insert bags too far into the
appliance. Only insert bag just over the edge of the removable
drip tray.