Service Manual
båÖäáëÜ
cê~å´~áë
25
4.3
Replacing the back panel
Removing the back panel
✔
The unit is switched off and the power cable is disconnected.
1. Remove the 6 screws from the back panel.
2. Pull off the back panel parallel to the back. NOTICE! Observe the
ground cable and button connection.
3. Carefully pull away the ground cable on the device side and
disconnect the link to the button connection.
4. Put aside the rear panel.
Mounting the back panel
1. Reinsert the ground cable and reestablish the link to the button
connection.
2. NOTICE! Do not jam in the ground cable or button connection.
Carefully place the rear panel back on.
3. Fasten the back panel securely with 6 screws.
Summary of Contents for MyCrown Design
