16
MyCrown Design
2. Route the following 3 cables through the feedthrough in the column:
LAN cable for radio module (A)
USB cable on the trackball unit (B)
heating cable (C)
3. Hang the control panel on the column. Both hooks on the control
panel must be mounted in the recesses in the column.
4. Fasten the control panel with 2 screws at positions (A) and (B). The
protective ground wires will be screwed in later using the third screw.
Summary of Contents for MyCrown Design
