41
OPERATION
SPIN PROGRAM RUN SCREEN
FIG. 61
RUN/PAUSE
PROGRAM
CANCEL
CYCLES REMAINING
INFEED BY .001"
OUTFEED BY .001"
DECREASE SPIN SPEED
INCREASE SPIN SPEED
If you wish to inspect the reel in the middle of a grind program, press PAUSE PROGRAM. The program will
finish the traverse cycle it is currently on and then stop at the
HOME
position. You can then open the doors
and check the reel. If you wish to continue press RUN or press the CANCEL button to end the program.
When the program is complete the dust collector, spin motor, traverse motor, and grinding motor will turn
off. The blue light on top of the grinder will flash to signal that the program is complete. Open the doors and
inspect the reel.
NOTE: At this point the reel has been sharpened with the SPIN GRIND process. If you do not want to RELIEF
GRIND, simply remove the reel and SPIN GRIND the next reel. If you want to RELIEF GRIND the reel, proceed
to the RELIEF GRIND process on the next page. If you wish to save the settings that were just run as a custom
program then press SAVE.
SPIN GRIND
Press to go to the SPIN
PROGRAM screen to select
another program and
continue to grind this reel.
SAVE
Press to go to the SAVE
PROGRAM SCREEN. The
values used can be saved into
a new program. See Page 49
for loading programs
RELIEF GRIND
Press to go to start the
relief grind process.
FIG. 62
SPIN DRIVE
MOTOR SPEED
LEVEL INDICATOR