7
1. Maximum lifting capacity is 400 pounds (180 kg.) in
a single line operation.
DO NOT ATTEMPT TO MOVE
LOADS GREATER THAN THE RATING.
2.
NEVER CARRY
personnel on the hook or the load.
3.
NEVER MOVE A LOAD
with this winch until all
personnel are clear.
4.
NEVER HOOK THE WIRE ROPE BACK ON ITSELF. USE
THE SPREADER BAR ASSEMBLY.
Hooking the wire rope
back on itself creates an unacceptable strain on the
wire rope.
5.
DO NOT ALLOW
unqualified personnel to operate
this unit.
6.
KEEP CLEAR OF WINCH WIRE ROPE AND HOOK
WHEN OPERATING WINCH. DO NOT ATTEMPT
to
guide wire rope by hand as it rewinds.
7.
DO NOT
use the wire rope as a ground for welding.
8.
NEVER TOUCH
a welding electrode to the wire rope.
9.
WHEN SPREADER BAR ASSEMBLY IS USED
be sure it
is properly seated in the saddle of the hook.
10.
AVOID
excessive inching and quick reversals of
load.
11.
BE SURE
that the power supply is disconnected
before performing maintenance and repair procedure.
12.
DO NOT OPERATE
this unit if it is not functioning
properly.
13.
MAINTAIN A MINIMUM OF 4 TURNS OF WIRE
ROPE
around the winch drum to prevent the wire rope
from pulling off under load.
CAREFULLY READ ALL THE INSTRUCTIONS BELOW BEFORE
ATTEMPTING TO OPERATE OR SERVICE YOUR WINCH! FAILURE
TO COMPLY WITH INSTRUCTIONS COULD RESULT IN PERSONAL
INJURY, DEATH AND/OR PROPERTY DAMAGE!
14.
KEEP WINCHING AREA CLEAR
. Do not allow
people to remain in the winching area. Do not
stand between the winch and the load.
15.
INSPECT WIRE ROPE FREQUENTLY
. A frayed
wire rope with broken strands should be replaced
immediately. Never replace the wire rope with
rope of any kind or with wire rope other than the
type and size specified in the repair parts section of
this manual.
16.
USE HEAVY LEATHER GLOVES
when
handling the wire rope to eliminate the possibility
of cuts or scratches from burrs and slivers from
broken strands.
17.
ALLOW WINCH TO COOL DOWN
FREQUENTLY (Electric Winch)
, as the motor is
designed for intermittent duty only. When the
metal motor housing is hot to touch, it is time to let
the winch cool down
18.
DO NOT OPERATE WINCH WHEN UNDER
THE INFLUENCE OF DRUGS, ALCOHOL, OR
MEDICATION.
19.
DO NOT USE WINCH TO HOLD LOADS IN PLACE
.
Use other means of securing loads, such as tie
down straps.
20.
USE ONLY FACTORY APPROVED, PARTS,
SWITCHES, REMOTE CONTROLS AND ACCESSORIES
.
Use of non-factory approved components may
cause injury or property damage and could void
your warranty.
21.
DO NOT MACHINE OR WELD ANY PART OF THE
WINCH
. Such alterations may weaken the structural
integrity of the winch and could result in personnel
injury and void your warranty.
22.
DO NOT OPERATE THIS WINCH OUT DOORS OR
IN A CORROSIVE OR EXPLOSIVE ENVIRONMENT.
SAFETY INSTRUCTIONS
