28
ALIGNING REELS IN THE VERTICAL PARALLELISM
PLANE
1. Move the grinding head assembly until the
set up fixture is approximately 1" from the
right side of the reel. Lock the Knob A within
approximately 1/8" .125" (3MM) of center shaft
of the reel. See FIG. 46.
2. Raise the indicator slide casting on the vertical
support so that the indicator rod can be
extended over or under the center shaft of the
reel. See FIG.44 and 45.
3. Lower the indicator slide by turning the vertical
fine adjustment Knob B until the alignment rod
lightly touches the top or bottom of the reel
center shaft. See FIG. 47.
4. Pull rod back and lock Knob C. See FIG. 46.
Traverse to the other side of reel, same distance
from end. Loosen Knob C and extend alignment
rod.
5. If the left side is lower than the right, turn the
vertical adjusting handwheel in the cross slide
assembly clockwise raising the mounting bar and
the reel until the center shaft of the reel lightly
touches the extended indicator rod. See FIG. 49.
If the left side of the reel is found to be higher
than the right, lower the mounting bar and reel
until alignment rod lightly touches the extended
indicator rod.
ALIGNMENT ROD
TOP OF CARRIER SHAFT
VERTICAL
PARALLELSIM
KNOB
A
KNOB B
KNOB C
KNOB B
FIG. 47
FIG. 46
FIG. 45
FIG. 44
OPERATING INSTRUCTIONS