24
Commissioning
Fig. 4-13 Rear wall of the automatic feeder
1
Control box cover plate
2
External ball valve cable
8. Unscrew the cover plate from the control box of the automatic feeder.
9. Feed the external ball valve cable through the feed-through grommet.
Fig. 4-14 Automatic feeder rear wall interior
1
Cable fastener
2
External ball valve cable
10. Route the external ball valve cable through the cable gland to the circuit board.
11. Connect the external ball valve cable according to the circuit diagram.
12. Install the control box cover plate.
13. Screw the discharge pipe onto the front of the automatic feeder.
Note:
If a supplementary liquid dosing unit is installed, the supplementary dosing unit hose
is fastened using the same screws as the discharge pipe.
Fig. 4-15 Discharge pipe installed on the front of the automatic feeder
14. Install the powder funnel.
1
2
1
2
1
