Operating Manual EMGZ 321.EIP
19.10.2017
15
4.2
Preparations for System Configuration
In order to facilitate the configuration of the tension monitoring system it is
advisable to adapt some basic system parameters to the specific requirement of
the application.
1.
Adopt password
2.
Set the language on the display
3.
Set measuring unit
Above features are changed in the 8.8 “System Parameter Group”. Please refer to
Fig. 17
to 19
to visualise the following parameter changing procedures:
A) Adopt Password
The password cannot be changed. It is always 3231. However, it can be adopted or
disabled. If adopted, the system will request the password for every parameter
change. If you wish to adopt the password,
follow the following instructions:
1.
Hold the
key for longer then 3 sec. until you enter the Parametrisation State.
2.
The display shows
.
Scroll the menu by pressing
the key until you
are
in the parameter group “System”.
3.
Press
. The display shows
.
4.
Press again
. The display starts flashing indicating that you can now change
the parameter with the
or
keys
.
5.
To confirm your change by pressing the Enter key
.
6.
Press the
key twice, if you want to return to the Operation State. If you
desire to change the language, continue with the steps below.
B) Change Language
The default setting for the language is English.
1.
Press to select the Parameter
Language
2.
Press again
. The display starts flashing indicating that you can now change
the parameter with the
or
keys
.
3.
Set your language
4.
To confirm your change by pressing the Enter key
.
5.
To change the measuring units continue with next paragraph C)
6.
Press the
key twice, if you want to return to the Operation State. If you
desire to change the measuring unit, continue with the steps below.
Language
English
Password
No
Amp.
*******
