EN
06
4
、Power Off
1.Disconnect the receiver power.
2.Toggle the transmitter's power switch to the off position.
Follow the steps below to turn off the system:
System Functions
This section focuses on the functions and how to use them.
1
、Channel Description
The transmitter outputs a total of 4 channels, which are allocated as follows:
N
ote:
By defaul
t
t
he
output o
f CH4 is 1000us,
after
whic
h p
ressing
t
he
button will toggl
e
bet
ween
1000 and 2000us.
2
、Channel Reverse
3
、
Trims
For multiplexing switching mode, see [5.5 Mode Switching].TH.TRIMis the trims for CH2(throttle).
Adjustment range: -120us- + 120us, each step is 4us;
ST.TRIM + / TH.TRIM +: increase adjustment step;
ST.TRIM- / TH.TRIM-: Decrease adjustment step.
The ST
.TRIM is the trims for CH1 (steering),and can be multiplexed as
T
rims of CH3 and CH4.
LED Indicator:
1. CH1：Steering Wheel 2. CH2：Throttle Trigger
3. CH3：Three-position Switch 4. CH4：Reset Button
Danger
Make sure to disconnect the receiver power before turning off the transmitte
r
. Failure to do
so may lead to damage or serious injur
y.
This function is used to adjust each channels direction of movement in relation to it’s input.
The ST.REV / TH.REV switches are the reverse buttons for CH1 and CH2. If the switch is up it indicates
reverse, and the down indicates normal.
When using the trim keys the G.LED will flash slowly on short presses and quickly on long presses.
When the fine adjustment value is at the midpoint, the G.LED will flash twice slowly.
When the fine adjustment value is at both ends (+ 120us / -120us), the trim adjustment is at its maximum
and as such G.LED will not flash(if the fine adjustment value has been adjusted to + 120us, then press
ST.TRIM + / TH.TRIM + key is invalid and G.LED has Instructions)
