FMS CMGZ433 Series, Operating Manual

Page: 30 / 45

Operating Manual CMGZ433
30
11 Parametrization
11.1 Parameter list
Parameter Unit Default Min Max Actual
Find offset (Parameter function)
Calibration feedback (Parameter function) _______
Auto. diameter adjust (Parameter function)
1)
Adjustm. of pilot control (Parameter function)
1)
Offset feedback [Digit] 0 -4000 4000 _______
Gain feedback [-] 1.000 0.100 9.000 _______
Nominal force [N,kN] 1000 1 9999 _______
Unit of force [N,kN] N N kN _______
Sensitivity [mV/V] 1.8 0.1 3.0 _______
1 or 2 sensors [-] 1 1 2 _______
Lowpass output [Hz] 50.0 0.1 200.0 _______
Lowpass instrument [Hz] 1.0 0.1 10.0 _______
Lowpass display [Hz] 1.0 0.1 10.0 _______
Scale instrument [-] 1.00 0.01 10.00 _______
Limit 1 min / max Min, Max Max _______
Limit value 1 [N,kN] 0 -9999 9999 _______
Limit 2 min / max Min, Max Min _______
Limit value 2 [N,kN] 0 -9999 9999 _______
Language English, German, French, Italian _______
Pilot control No, Internal, External _______
Influence of PI
2)
[%] 100.0 0.1 100.0 _______
PID-configuration
2)
PI, PID PI _______
Proportional P0
2)
[-] 1.00 0.01 100.00 _______
Integral I0
2)
[s] 1.00 0.01 100.00 _______
Derivative D0
2)
[s] 0.010 0.001 10.000 _______
Proportional P1
2)
[-] 1.00 0.01 100.00 _______
Integral I1
2)
[s] 1.00 0.01 100.00 _______
Derivative D1
2)
[s] 0.010 0.001 10.000 _______
Proportional P2
2)
[-] 1.00 0.01 100.00 _______
Integral I2
2)
[s] 1.00 0.01 100.00 _______
Derivative D2
2)
[s] 0.010 0.001 10.000 _______
Proportional P3
2)
[-] 1.00 0.01 100.00 _______
Integral I3
2)
[s] 1.00 0.01 100.00 _______
Derivative D3
2)
[s] 0.010 0.001 10.000 _______
Alarm limit error [%] 10.0 0.1 100.0 _______
Output limit [%] 100.0 10.0 100.0 _______
1)
Is displayed only if pilot control is active
2)
These parameters may be changed also while the controller is enabled. Setting is done
as written under „11.3 Description of the parameters“. The new values are taken for
the control loop when parameter mode is quit.