FMS CMGZ433 Series, Operating Manual

Page: 28 / 45

Operating Manual CMGZ433
28
RP15<CR> X<CR> display language
RP16<CR> X<CR> pilot control
RP17<CR> XXX.X<CR> influence of PID
RP18<CR> X<CR> PID-configuration
RP19<CR> XXX.XX<CR> proportional P0
RP20<CR> XXX.XX<CR> integral I0
RP21<CR> XX.XXX<CR> derivative D0
RP22<CR> XXX.XX<CR> proportional P1
RP23<CR> XXX.XX<CR> integral I1
RP24<CR> XX.XXX<CR> derivative D1
RP25<CR> XXX.XX<CR> proportional P2
RP26<CR> XXX.XX<CR> integral I2
RP27<CR> XX.XXX<CR> derivative D2
RP28<CR> XXX.XX<CR> proportional P3
RP29<CR> XXX.XX<CR> integral I3
RP30<CR> XX.XXX<CR> derivative D3
RP31<CR> XXX.X<CR> alarm limit error
RP32<CR> XXX.X<CR> output limit
RP33<CR> X<CR> output config.
RP34<CR> XX.X<CR> ramp diameter
RP35<CR> XX.X<CR> ramp reference
RP36<CR> X<CR> reference internal / external
RP37<CR> XXXX<CR> scale of reference
RP38<CR> X<CR> tension reduction
RP39<CR> X.XXX<CR> reduction factor
RP40<CR> XXX.XX<CR> start speed
RP41<CR> XXX.X<CR> start limit
RP42<CR> XXXX<CR> leading drive
RP43<CR> XXXX<CR> controlled drive
RP44<CR> XXXX<CR> tacho diameter
RP45<CR> XXXX<CR> center diameter
RP46<CR> XXXXX<CR> max. diameter
RP47<CR> XXX<CR> Identifier
RP48<CR> X<CR> baud rate interface
RP49<CR> X<CR> data bit interface
RP50<CR> X<CR> stop bit interface
RP51<CR> X<CR> parity bit interface
All parameter numbers refer to the parameter list.
10.4 Write parameter
command answer purpose
WP01XXXXX<CR> PACC<CR> / FAIL<CR> offset feedback
WP02X.XXX<CR> PACC<CR> / FAIL<CR> gain feedback
WP03XXXX<CR> PACC<CR> / FAIL<CR> sensor, nominal force
WP04X<CR> PACC<CR> / FAIL<CR> sensor, force unit
WP05X.X<CR> PACC<CR> / FAIL<CR> sensor, sensitivity
WP06X<CR> PACC<CR> / FAIL<CR> number of sensors
WP07XXX.X<CR> PACC<CR> / FAIL<CR> lowpass, feedback
WP08XX.X<CR> PACC<CR> / FAIL<CR> lowpass, instrument
WP09XX.X<CR> PACC<CR> / FAIL<CR> lowpass, display
WP10XX.XX<CR> PACC<CR> / FAIL<CR> scale of instrument
WP11X<CR> PACC<CR> / FAIL<CR> limit 1 min / max
WP12XXXXX<CR> PACC<CR> / FAIL<CR> limit value 1