www.fmiproducts.com
119303-01G
5
PRODUCT IDENTIFICATION
Figure 1 - Log Base Assembly
Log Set
Base
Assembly
Front
Burner
Rear
Burner
Top Louver
Assembly
Fireplace
Hood
Bottom Louver
Assembly
Screen
Assembly
Top Outer Casing
Figure 2 - Fireplace
UNPACKING
Blower Assembly
BLOWER ASSEMBLY
This fireplace has a blower assembly. The
blower operates thermostatically and has a
variable speed control. The blower circulates
heated air from the fireplace into the room.
Use of blower is optional.
THERMOSTAT CONTROL
This fireplace has a thermostat sensing bulb
and control valve. The thermostat controls the
heat output and flame height. This maintains
a consistent room temperature. Even the
lowest setting provides realistic flames and
glowing embers from two burners. Selecting
higher comfort settings allows fireplace to run
longer, producing greater heat output. At lower
comfort settings, the fireplace will run less.
This results in increased heating comfort. This
can also result in lower gas results.
CAUTION: Do not remove the
data plates attached to the heater
base assembly. The data plates
contain important warranty and
safety information.
1. With utility knife, cut carton all the way
around above staples on bottom tray. Lift
carton off of heater. Remove packing.
Note: Hood is located in packing on right
hand side of heater front. Lift heater off
bottom tray.
2. Locate two screws above top corners of
the fireplace screen. Remove and discard
these screws. Lift fireplace screen up and
pull out to remove.
3. Remove protective packaging applied to
logs, log base assembly, and fireplace.
4. Remove fireplace hood from carton insert.
5. Check all items for any shipping damage.
If damaged, promptly inform dealer where
you bought fireplace.
PRODUCT FEATURES
OPERATION
This vent-free fireplace is clean burning. It
requires no outside venting. There is no heat
loss out a vent or up a chimney. Heat is gen-
erated by both realistic flames and glowing
embers. When used without the blower, the
fireplace requires no electricity making it ideal
for emergency backup heat.
SAFETY DEVICE
This fireplace has a pilot with an Oxygen
Depletion Sensing (ODS) safety shutoff
system. The ODS/pilot is a required feature
for vent-free room heaters. The ODS/pilot
system shuts off the fireplace if there is not
enough fresh air.
PIEZO IGNITION SYSTEM
This fireplace has a piezo ignitor. This sys
-
tem requires no matches, batteries or other
sources to light fireplace.
