www.fmiproducts.com
115254-01C
18
INSTALLING LOGS
Models (V)L36(ZNR, LZNR, ZPR, LZPR)
and (V)L42(ZNR, LZNR, ZPR, LZPR)
WARNING: Failure to posi-
tion the parts in accordance
with these diagrams or failure
to use only parts specifically
approved with this heater may
result in property damage or
personal injury.
Each log is marked with a number. These
numbers will help you identify the log when
installing. It is very important to install these
logs exactly as instructed. Do not modify logs.
Only use logs supplied with heater.
Note: Your appliance may vary from model
shown but log placement will be the same.
1. Place ember bed in center of the base
assembly as shown in Figure 24.
2. Rest rear log in back corner sections of
base assembly as shown in Figure 24.
Make sure log is completely vertical and
not leaning in toward burner where the
flame will touch the log.
Base
Assembly
Figure 24 - Installing Ember Bed, Rear
and Middle Logs
Ember
Bed
Rear Log
Middle Log
INSTALLATION
Continued
Figure 25 - Installing Top Logs
Figure 26 - Installing Front Logs
Middle
Log
Top Left Log
Top Right Log
Left
Front
Log
Right Front Log
3. Position middle log as shown in Figure
24 making sure grooves in bottom of log
fit over grate prongs. This log will rest on
top of bottom log.
4. Place top right log onto pins of middle
log (see Figure 24). Bottom of top log will
rest on middle log as shown in Figures
25 and 26.
5. Place top left log on middle log as shown
in Figure 25.
6. Place right and left front logs against grate
as shown in Figure 26 to hide controls.
