www.fmiproducts.com
126116-01D
25
not use any phone in your building.
• Immediately call your gas supplier
from a neighbor’s phone. Follow the
gas supplier’s instructions.
• If you cannot reach your gas supplier,
call the fire department.
C. Use only your hand to push in control
knob. Never use tools. If the knob will
not push in or slide by hand, don’t
try to repair it, call a qualified service
technician. Force or attempted repair
may result in a fire or explosion.
D. Do not use this appliance if any part has
been under water. Immediately call a
qualified service technician to inspect
the appliance and to replace any part of
the control system and any gas control
which has been under water.
LIGHTING
INSTRUCTIONS
1. STOP! Read safety information in column
1 before proceeding.
2. Turn off all electrical power to appliance.
3. Remove screen door assembly.
4. Slide remote selector to OFF position.
5. Make sure manual shutoff valve is fully
open.
6. Push in gas control knob slightly and turn
clockwise
to OFF.
7. Wait five (5) minutes to clear out any gas.
Then smell for gas, including near floor. If
you smell gas, STOP! Follow B in safety
information in column 1. If you don’t smell
gas, go to next step.
8. Visually locate pilot assembly by main
burner.
9. Turn knob on gas control counterclock-
wise
to PILOT.
10. Push control knob all the way in and hold.
Immediately light pilot by pressing red ig-
nitor button until flame appears. Continue
to hold control knob in for about one (1)
minute after pilot is lit. Release knob and
it will pop back up. Pilot should remain lit.
If it goes out, repeat steps 6 through 10.
• If knob does not pop out when released,
stop and call service technician or gas
supplier.
• If pilot will not stay lit after several tries,
turn gas control knob to OFF and call
your service technician or gas supplier.
11. Turn gas control knob counterclockwise
to ON. Knob can be turned to ON
Figure 42 - Control Knob in Pilot Position
Position
Indicator
Gas Control
Knob
HI/LO Knob
OPERATION
Continued
only if control knob is popped out.
12. Set HI-LO knob to desired setting.
13. Slide remote sector switch to REMOTE
position to operate using remote control.
Selector switch must be in the ON position
to operate manually.
14. Turn on all electric power to appliance.
Note: It is recommended that you maintain
gas control knob in the full OFF position during
lengthy periods of seasonal nonuse.
Figure 43 - Pilot
Thermocouple
Pilot Burner
Piezo Ignitor
Thermopile
TO TURN OFF GAS
TO APPLIANCE
1. Turn off wall switch, if installed.
2. Turn off all electric power to appliance if
service is to be performed.
3. Remove screen door assembly
4. Slide selector switch to OFF position.
5. Push in gas control knob slightly and turn
clockwise
to OFF. Do not force.
6. Replace screen door assembly.
REMOTE OPERATION
Note: Remote receiver is factory installed with
this fireplace. Follow instructions included with
remote control.
NOTICE: You must light the pilot
before using the hand-held re
-
mote control unit. See
Lighting
Instructions
.
