www.fmiproducts.com
126116-01D
20
Lava Rock and Ember Material
1. For all models, place lava rock along sides
and front of firebox bottom in areas that
are visible. It is not necessary to use all
lava rock provided.
NOTICE: Do not put lava rock
on or under burner. Placing
lava rock on burner could cause
performance problems.
2. Pull ember material apart into pieces no
larger than a dime. Place loosely and di-
rectly onto exposed section of front burner
and along space between burner and grate
prongs. These will create glowing ember ap-
pearance as flame touches ember material.
Do not block air slots by using too much
ember material in one area. It is not neces-
sary to use all ember material provided.
3. When lava rock and ember material are
in place, close and latch glass door and
replace screen door assembly.
WARNING: The glass door
must be securely in place before
operating fireplace. Do not oper
-
ate fireplace if glass is missing
or broken.
DECORATIVE FACING
Any noncombustible material may be used as
facing (glass, tile, brick, etc.) as long as the
proper clearances are observed (see
Clear-
ances to Combustibles
, page 6). Screen door
assembly must not be obstructed and must
remain accessible for service. Use only heat-
resistant, noncombustible mortar or adhesive
when securing decorative facing materials.
OPTIONAL FACE EXTENSION FE-36M
Front face extension would add 3
1
/
2
" to
width and 3/4" to height of fireplace face.
To install face extension:
1. Remove existing screws from front face
assembly as shown in Figure 32.
2. Align holes on top face extension with
holes on top side of front face assembly
and secure with screws previously re-
moved (see Figure 32).
3. Align holes on right face extension with
holes on right side of front face assembly
and secure with screws previously re-
moved (see Figure 32). Do the same for
left side.
4. Secure top face extension with left and
right face extensions with two sheet metal
screws (see Figure 32).
Figure 32 - Front Face Extension
Side Face
Extensions
Top Face
Extension
INSTALLATION
Continued
5. Place log #5 (base log) onto front left part of
grate making sure notch and hole fit over
metal pin and prong of grate. See Figure 31.
6. Place log #6 (left log) onto rear log landing
and resting it on top of front log. See Figure
31.
Figure 31 - Installing Logs No. 5 and No. 6
5
6
Metal
Pin
Grate
Prong
Rear Log
Landing
