8
4.
Operation Instructions
After setting up, follow the instructions below to operate the system.
4.1 Power On
Follow the steps below to turn on the transmitter:
1. Make sure that：
• The battery is fully charged and installed correctly.
• The receiver is installed correctly and powered down.
2. Hold the power button until the screen turns on.
3. Connect the power supply to the receiver.
Note
• Operate with caution in order to avoid damage or injury.
Note
• Make sure that the throttle is at its lowest position and the switches are set to their up
position.
4.2 Binding
The transmitter and receiver have been pre-bound before delivery.
1. Connect the bind cable to the receiver's B/VCC port.
2. Connect power to any other port.
3. Select "Bind With A Receiver" in the transmitter's RX Setup menu.
4. Once binding is complete the transmitter will exit bind mode. Remove the power and bind cable from the
receiver then apply power to the B/VCC port.
5. Check to make sure everything functions as expected. If not repeat the steps above.
If you are using another transmitter or receiver, follow the steps below to bind the transmitter and receiver:
4.4 Power Off
Danger
• Make sure to disconnect the receiver power before turning off the transmitter. Failure
to do so may lead to damage or serious injury.
Follow the steps below to turn off the system:
1. Disconnect the receiver power.
2. Hold the transmitters power button until the screen turns off.
4.3 Transmitter LED Indicator
This LED has six colors, green, blue, cyan, red, yellow, white and off which can be set according to user preference.
To change the LED color see the LED Strip section of this user manual.
