13
7. Check the distance/space from the tooth of
Drive Shaft
and from tooth of
Pump
Shaft; Minimum distance
must be 0,65mm “0 Plus 0,1mm”
8. After remove the
Plate, the Bell and the Pump without disconnect this 3
parts!
During installation and maintenance be sure that no pipe or electric cable is near
to potential electrical shortcuts, electrical shocks (always possible especially
coming from high voltage cables candles) and close to hot surfaces (above 50 °
C ..) Do not run pipes or wires inside holes on not properly protected sheets, do
not lean them on sharp edges or on any other cutting element. The thermal
expansion of materials and their vibrations during operation of the engine can
cause cuts, peeling and abrasion of the objects placed in contact with them.
If you have choose a Fuel Pump for Electronics Fuel Injection E.F.I., insert a
specific filter for injection systems which is resistant to injection pressure of 3 bar
between the output pump and the input rail of injectors in order to be able to
retain any dirty or waste
With regards to the connection of the pressure / vacuum, instead, use suitable pressure tube
resistant to pressure and especially to gasoline and oil.