MAX OWNER’S MANUAL VER . 2.0
___________________________________________________________________________
©
Copyright di
FLY
Products
s.r.l.
Pagina
14
Spark plug
Set the spark plug gap to 0.025” (0.635mm). Install the spark plug and torque to specifications
(120-inch lbs. or 10 ft- lbs.).
Assembly inspection
It is critical to fully inspect the assembly of the
MAX
to find and remedy any potential problem areas
before proceeding.
The inspection should contain, at a minimum, the following items:
?
Review each assembly step above
?
Examine all nuts, bolts, and fasteners for security
?
Check the ha rness for correct mounting, that all straps are secure, that there are no
twists on any straps
?
Examine prop cage for correct assembly, that it is strong, the netting is tight and on the correct
side
?
Check that nothing can get in the prop. The prop should clear the cage by same distance at all
points.
?
Check the fuel tank and fuel delivery system.
?
Check for correct mounting of prop, and correct torque of prop bolts.
3.0
PREPARING FOR YOUR FIRST
FLIGHT
Fuel and Oil
FLY PRODUCTS recommends the use of a premium unleaded automotive gasoline of 92 octane or
higher, and the use of premium synthetic 2-cycle oil. Mix fresh gas and oil before each flying session.
Store your fuel/oil mixture in an approved, sealed container. Dispose of fuel/oil mixture that is older
than 72 hours.
The recommended fuel/oil ratio is 2%. Be sure to thoroughly agitate the mixture to completely dissolve
the oil.
Use only fresh fuel and oil, and use clean containers, funnels, hoses, etc.
Summary of Contents for MAX 100
Page 1: ...MAX 100 and MAX 130...
