14
OptiView
TM
Series III
Getting Started Guide
Management configuration mode user commands:
Network configuration mode user commands:
“ipaddr A.B.C.D E.F.G.H”
“ipaddr dhcp”
Statically assigns the IP address (A.B.C.D) and subnet mask
(E.F.G.H) of the Management Port. Address and subnet mask
are entered in decimal dot notation.
Enables the automatic configuration of the Management Port
IP parameters via a DHCP server. This occurs when “apply” is
entered (see below). It will then attempt to aquire an IP
address from the DHCP server if link is available.
“iprouter A.B.C.D”
Statically assigns the IP address (A.B.C.D) of the default router
on the Management Port. Address is entered in decimal dot
notation.
“apply”
Applies the changes (if any) made to the Management Port
configuration. Management Port configuration changes do
not take effect until this command is entered.
“exit”
Exits the Management configuration mode. Exiting will
discard any Management Port configuration changes unless
‘apply’ is entered.
“show
(user command)”
Displays the current value of an individual setup parameter of
interest within the Management configuration mode.
“show all”
Displays the current values of all setup parameters within the
Management configuration mode.
“ipaddr A.B.C.D E.F.G.H”
“ipaddr autoconfig”
Statically assigns the IP address (A.B.C.D) and subnet mask
(E.F.G.H) of the Network port. Address and subnet mask are
entered in decimal dot notation.
Enables the “Auto Reconfigure” command which
reconfigures the TCP/IP connection. This occurs when “apply”
is entered (see below). It will then attempt to autoconfigure
an IP address if link is available. It will first look for a DHCP
server. It it does not find one, it will generate an IP address
based on the network activity it sees.
“autoconfig enable/disable”
Enables or disables the “Auto Configure on Network Change”
checkbox. See the TCP/IP Help topic for a description of use.
“iprouter A.B.C.D”
Statically assigns the IP address (A.B.C.D) of the default router
on the Network port. Address is entered in decimal dot
notation.
“ippridns A.B.C.D”
Statically assigns the IP address (A.B.C.D) of the primary
Domain Name Server (DNS) on the Network port. Address is
entered in decimal dot notation.
“ipsecdns A.B.C.D”
Statically assigns the IP address (A.B.C.D) of the secondary DNS
on the Network port. Address is entered in decimal dot
notation.
“apply”
Applies the changes (if any) made to the Network port
configuration and runs “Auto Configure on Network Change”
if specifiied by “ipaddr autoconfig”. Network port
configuration changes do not take effect until this command
is entered.
Summary of Contents for OptiView III Series
Page 4: ......
Page 29: ...23 Workgroup Analyzer Safety and General Specifications...
Page 33: ......