9118A
Users Manual
2
•
Use the Product only as specified, or the
protection supplied by the Product can be
compromised.
•
Do not use the Product around explosive gas,
vapor, or in damp or wet environments.
•
Use this Product indoors only.
•
Use only the mains power cord and connector
approved for the voltage and plug
configuration in your country and rated for the
Product.
•
Replace the mains power cord if the insulation
is damaged or if the insulation shows signs of
wear.
•
Connect one end of the supplied ground wire
to the protective earth ground terminal on the
rear panel and the other end to an earth
ground.
•
Make sure the ground conductor in the mains
power cord is connected to a protective earth
ground. Disruption of the protective earth
could put voltage on the chassis that could
cause death.
•
Do not put the Product where access to the
mains power cord is blocked.
•
Make sure that the Product is grounded before
use.
•
Do not use an extension cord or adapter plug.
•
Do not use the Product if it operates
incorrectly.
•
Do not use the Product if it is damaged.
•
Disable the Product if it is damaged.
•
Make sure the power cord does not touch with
hot parts of the Product.
•
Make sure that the space around the Product
meets minimum requirements.
•
Do not keep the Product in operation and
unattended at high temperatures.
•
Use caution when you install and remove
probes and inserts from the Product. They can
be hot.
•
Do not put the Product on a flammable surface
and keep a fire extinguisher nearby.
•
Do not set anything on top of the Product. Very
high temperatures can cause the ignition of
flammable materials.
•
Do not remove the isothermal block and rear
plug at high temperatures. The isothermal
block and rear plug are the same temperature
as shown on the display.
•
Do not lift or move the Product with the
isothermal block in place. The isothermal
block and rear plug may fall out of the
instrument.