FW-F093-P-MAN-EN_v0101_01
Page 7
2.3.
OPERATOR INFORMATION AND FUNCTIONS
In general, the F093-P will always act at Operator level. The information displayed is dependent
upon the SETUP-settings. The signal generated by the connected Tachometer is measured by the
F093-P in the background, whichever screen refresh rate setting is chosen. After pressing a key, the
display will be updated very quickly during a 30 second period, after which it will slow-down again.
Auto toggle
Fig. 3: Example of display information during process.
For the Operator, the following functions are available:
•
Display engine speed / running hours or engine speed only or running hours only
This is the main display information of the F093-P. After selecting any other information, it will
always return to this main display automatically.
Running hours is displayed on the upper-line of the display and engine speed on the bottom
line.
It is possible to display engine speed only with the large 17mm digits; in this instance press
the SELECT-key to read the running hours.
When "-------" is shown, then the engine speed value is too high to be displayed. The arrows
indicate the increase/decrease of the engine speed trend.
•
Clear running hours
The value for running hours can be re-initialized. To do so, press CLEAR twice. After pressing
CLEAR once, the flashing text "PUSH CLEAR" is displayed. To avoid re-initialization at this
stage, press another key than CLEAR or wait for 20 seconds.
Re-initialization of running hours DOES NOT influence the accumulated running hours.
Note: I
f pressing CLEAR twice does not clear the running hours, the F093-P is configured not to
allow this in Operation mode.
•
Display accumulated running hours
When the SELECT-key is pressed, running hours and accumulated running hours are
displayed. The accumulated running hours cannot be re-initialized. The value will count up to
99,999,999,999. The unit and number of decimals are displayed according to the
configuration settings for running hours.
