Rev A1
FT900003
3 of 14
SPECIFICATIONS
Step One
Set point range:
FT10: .04 to 3 fps (.012 to .91 mps)
GT10: 1 to .90 fps (.3 to 27 mps)
Factory set point:
FT10: .2 fps (.06 mps)
GT10: 10 fps (3 mps)
Repeatability:
±.5% of set point @ fixed temp.
Response time:
1‐10 seconds
Set point adjust.:
Potentiometer
LED indication:
Flow Status
Viscosity range:
1‐200 centipoise (FT10 only)
Supply Voltage:
14‐36 VDC
Consumption:
70 mA maximum
Contact type:
(1) SPST relay
Contact rating:
60 VA, 1A max
Contact output:
Selectable NO/NC
Process temp.:
F:32° to 140°
C: 0° to 60°
Electronics temp.
F: ‐40° to 140°
C: ‐40° to 60°
Pressure:
150 psi (10 bar) @ 25°C., derated @ 1.667
psi (.113 bar) per °C. Above 25° C.
Sensor rating:
NEMA 4X (IP65)
Sensor Material:
1_ _5: PP‐Ryton®
5_ _5:PVDF
Cable jacket mat.:
1_ _5: PP
5_ _5: FEP
Cable type:
4‐conductor, #22 AWG (shielded)
Cable length:
Standard: 10’ (3m)
Special order: 25’ (7.6m) or 50’ (15.2m)
Process mount:
3/4" NPT (3/4” G/R)
Mount. Gasket:
Viton® (G version only)
Classification:
General purpose
CE compliance:
EN 61326 EMC
EN 61010‐1 safety
Make a Fail‐Safe System:
Design a fail‐safe system that accommodates the possibility of switch and/or
power failure. FLOWLINE recommends the use of redundant backup systems and alarms in addition to the
primary system. Adding a redundant alarm switch to the system is a cost effective means to prevent costly
run‐dry issues.
